1.トランクドアを開けて、最後部の [LEXUS] 又は [SOARER] のロゴが入ったトップパネルを外します。
2.トランク左右のトレイと工具収納ボードを外し、最後部のパネルを外します。
（上の隙間からコネクターにアクセスできれば、ボードやパネル等を外す必要はありません）
3.トランク後壁部中央付近にあるコネクターを外します。
4.そのコネクターに製品のコネクターをサンドイッチ接続します。
5. 右側のテールライトに近いトランクのウェザーストリップを持ち上げて、その隙間から製品のLEDライトの先端をトランク内部からバンパー外側へ通します。
6.配線の平らなテープ部分を折り曲げてウェザーストリップ部分に挟み込んで元の状態に戻します。
7.製品のLED部分を、位置決めをしっかり行ってから両面テープでパンパーの最上部に沿って貼り付けます。
Super Soarer Satoshi Sasaki Japan
Thank you very much for looking at this product. [1 in stock]
Yahoo Auctions cannot be used directly from outside Japan.
■Therefore If you wish to make a purchase from outside of Japan or have it delivered internationally,
please purchase from the proxy purchasing site called buyee below.
First, you will be notified that the link will take you to a page outside of Yahoo! Auctions. Clicking on the URL in the center of the page will take you to the Buyee site.
Please select the product then press ［Win now for Buyout Price］ at the page
Afterward, you need to register your email address and name.
This product is not a prohibited item for international purchase.
This is a horizontal LED light exclusively for the Lexus sc430 and 40 Soarer.
It lights up in conjunction with the original small parking lights.
Please refer to the pictures and follow the steps below to install.
1.Open the trunk door and remove the top panel cover with the [LEXUS] or [SOARER] logo on it.
2.Remove the tool storage board and then remove the rear wall panel of the trunk.
3.disconnect the connector located inside the center of the rear end of the trunk.
4.Sandwich insert the product connector.
5. Lift up the weather strip closest to the right tail light and pass it through the tip of the LED part of the product to the top of the bumper.
6.Bend the tape part of the wiring to return the weather strip to its original state.
7.Stick the LED part of the product along the top edge of the rear bumper.
The connector, LED length, and the method of pulling the wiring into the trunk have all been customized for the Lexus sc430 and Soarer, so it fits perfectly.
After assembling the product, we thoroughly check the continuity of the wiring system before completing the product.
A fuse is wrapped around the wiring connector.
It is attached with a strong adhesive tape, but please remove any dust or oil from the adhesive surface before attaching it. When removing it, please be careful not to peel off the paint of the bumper by warming it with a hair dryer while peeling it off.
Please note that the wiring may be cut if pulled with too much force.
The LED light body is made of a flexible material, so please note that it is less weather resistant than the quality of the genuine product.
Depending on the year of your vehicle, it may not meet safety standards of your country, so please check for yourself.
This is a private listing, so please install and use at your own risk.
If the product does not light up after purchase and installation, we will replace the product or refund you the defective product. Please contact us supersc430@gmail.com
Please refrain from refunds for reasons other than product defects.
We will strive to provide after-sales service such as answering questions about installation methods and the product itself. Thank you.
Buyee is the most trusted company offering secure payments and
fast, reliable and affordable international shipping for Japanese products.
Shipping from me to the Buyee warehouse in Japan is free.
The buyer then pays the international shipping charges to Buyee.
For example, shipping from Japan to all of the United States is about $25.
Excluding shipping, the minimum brokerage fee to Buyee is less than $3.
The buyer will pay these shipping fees after the item has been inspected at the buyee warehouse.
Please do not miss any communications from buyee.
Shipping packaging is 5cmx20cmx25cm and 230g.
Thank you.
Satoshi Sasaki Japan
Super Soarer Sc430
Yahoo Auction
Yahoo Shopping
Rakuten
247